This step ensures all motors start at the same time and respond equally to your throttle: : Ensure propellers are OFF .
: Place the flight controller (FC) on your frame with the LCD facing the front of the craft and the buttons toward the back.
: Wait for the confirmation beep (idle signal) and release the buttons. 4. Arming and Flying kk2.jpg
: Use the on-board "PI Editor" to adjust the gain settings if your drone feels shaky or sluggish. Beginners can often start with the default firmware settings provided by DroneTrest. KK2.1 Flight Controller Guide - Guides
: Hold down Buttons 1 and 4 on the KK2 board and keep them pressed. Power Up : Plug in the drone's battery. This step ensures all motors start at the
: Connect your Electronic Speed Controllers (ESCs) to the right side of the board. Ensure you use the correct motor layout for your frame type (e.g., Quadcopter X or +).
: Plug your receiver outputs into the left side of the board. Follow the pin definitions for Aileron, Elevator, Throttle, and Rudder. kk2.jpg
: Turn on your transmitter and set the throttle to maximum.