AgTalk Home
AgTalk Home
Search Forums | Classifieds (87) | Skins | Language
You are logged in as a guest. ( logon | register )

Saints Row 4 по сети Disabled transmission on jd 8310
View previous thread :: View next thread
   Forums List -> Machinery TalkMessage format
 
pirlbeck
Saints Row 4 по сети
Saints Row 4 по сети Posted 3/25/2021 07:48 (#8914531 - in reply to #8913926)
Subject: RE: Disabled transmission on jd 8310


West Central Iowa

Saints Row 4 Рїрѕ Сѓрµс‚рё -

Competing for the gold medal in "Insurance Fraud" or "Genki’s M.O.M." adds a layer of tension to the standard grind. Technical Setup and Stability

You can coordinate flight paths to rain down death from above, effectively covering 360 degrees of the battlefield.

Both players should ideally be on the same storefront (Steam or Epic) to ensure the friend-invite systems work seamlessly. Saints Row 4 по сети

A mini-game where one player drives while the other attempts to stay on top of the car.

Because the game tracks fast-moving superheroes, a low-latency connection is vital to prevent "rubber-banding" during high-speed flight. Competing for the gold medal in "Insurance Fraud"

While you are on the same team, the game encourages a healthy dose of rivalry through "Co-op Diversions."

Playing "по сети" today generally requires a few modern considerations: A mini-game where one player drives while the

Progress made in a friend’s world carries back to your own, including leveled-up powers and unlocked gear. The Ultimate Punchline



I thought I would add this just in case someone runs into this problem WITHOUT having a fuse in the DIA location.

The DTAC solution # is 71449 dated 12-22-2010.

Solution Summary: 00/10/20 W/T tractor goes into diagnostic mode on its own.

Complaint or Symptom: Tractor goes into Diagnostic mode while operating in the field. Corner post display stops showing engine RPM and displays DIA while engine is running. Tractor can be shut off and restarted to return to normal operation. Circuit 312 acquires enough voltage from other circuits to place controller into diagnostic mode without a fuse in diagnostic mode position F10.

Solution: Insert a male spade terminal into diagnostic fuse F10 for circuit 312 (non-powered side). Connect the other end of this wire to a ground terminal in the power strip. This prevents circuit 312 from causing controllers to go into diagnostic mode without a fuse installed in position F10.

CAUTION: Make certain to use a voltmeter to identify which side of fuse holder F10 does not have 12 volts applied to it. Non-powered side of fuse F10 is connected to circuit 312.

I had a 8410 a couple of years ago with this problem and a ground wire cured it.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)